Hi
Im using the latest Hurco Inspect post.
I want to use the probe geometry function to measure some bores.
Code works
I got the Macros
But where is it storing the measurement results?
%
O9004
(Using high feed G1 F24000. instead of G0.)
(T99 D=6. CR=3. - ZMIN=10.8 - probe)
N1 G90 G17
N2 G21
N3 M59
N4 G0 M140
N5 G53 X0. Y406.
(Probe Geometry1)
N6 T99 M6
(Renishaw OMP60 6mm x 75mm)
N7 M19
N8 M26
N9 M41
N10 G54
N11 G1 X0. Y0. F24000.
N12 G0 G43 Z84.5
N13 PCLOS
N14 POPEN
DPRNT[START]
DPRNT[RESULTSFILE*10-2-RESULTS]
DPRNT[DOCUMENTID*cc962088-b50c-4c97-a96c-568e0388b372]
DPRNT[MODELVERSION*95be5a6b-bc1c-4e9f-9d48-dbf4119c2523]
DPRNT[TOOLPATHID*180]
DPRNT[CYCLEDEPTH*13.8]
DPRNT[G331*N1*A-90.*B39.382*C-90.*X114.*Y0.*Z0.]
DPRNT[G330*N1*A0.*B0.*C0.*X0*Y0*Z0*I0*R0]
N15 G65 P9810 Z34.5 F3000.
N16 G65 P9810 Z10.8
N17 G65 P9814 D20. Q3. W1.
N18 G65 P9810 Z34.5
N19 G0 Z84.5
DPRNT[END]
N20 PCLOS
N21 G0 M140
N22 G53 G0 X287. Y406.
N23 M61
N24 M2
E
