I want to create a special tool for chamfer tools according to the bigshowa catalog in to the fusion 360 tools library

[thien117]

I wanted to make tools non-center beveled tools that is standard in the tools library.

bigshowa tools the second tools I want to make

 

[marcus.toepke]

Shouldn't that simply be the result of a rotational siluette?
With a tip diameter of ØCmin - 2*Hmin?

[da_fish]

That's the way I do it. You have to do a little trigonometry to figure out what to tip diameter should be if the tool had a corner radius. Then add the amount that the insert is offset.

[programming2C78B]

you can also sketch it as a form tool and get all your numbers off that 😉

[thien117]

there is no data in this file
and i feel it is not correct

[thien117]

 

Can you give me more specific instructions?

with chip parameters and tool shapes according to the manufacturer's catalog into the fusion 360 library

[thien117]

I used to do it your way but the chip center has to coincide with the tools center line in this case it is off by a distance

[marcus.toepke]

@thien117 
the Tooll was in this file

[CRANDALLPRECISION]

Just import a step file like every other cam software. Oh that's right, never mind.

[seth.madore]

---

@CRANDALLPRECISION wrote:

Just import a step file like every other cam software. Oh that's right, never mind.

---

We're working on it! 😭

[da_fish]

Here is a sketch that figures this out for you. 

If you open the parameters window you will see that I added parameter names so you can easily  change the insert/holder specs.

Enter the information in the parameters window and then enter the Tip Diameter parameter in to the tool settings page.

I hope this makes sense.