How To Do A Single OD Groove Plunge in Turning? file attached

[utekcnc]

I always have trouble doing a single groove plunge with grooving in Fusion.   Any tips?  file attached.

[seth.madore]

In this case, don't use "Groove", but rather, "Single Groove":

Now, for reasons I've not quite figured, out, I still need to put in an axial offset. In theory, it should be going right to the correct position, but it turns out that it still needs a -.0167" axial offset. Looking into that....

Silly me. The offset needs to be there because you only have a partial arc. If it was a full 180 sweep, no offset would be needed. So, input a value of -.0167" OR create a sketch arc (180 degree sweep) to properly select the end point.