Hello!
I have difficulty trying to find a tutorial online to make patterns by using the available toolpaths on Fusion360. Is it possible to generate the patterns below using the available toolpaths or do I have to manually model it out?
The patterns shown below are on a curved surface, but for my model I'm doing it on a flat surface.
I'm trying to find a more efficient solution to go about this 🙂
Patterns images are from here.
Hi @tehxiayin, In the manufacture workspace patterning is used for multiple outputs of a single part file, basically program once and make a ton of the same part. Some of your examples fit into a pattern that could be achieved, others would have to be manually done as they are more of a design than a pattern. Although the if the design was repeated then yes. That said it can be done if it is a linear or circular pattern, I found an older post with an example. PATTERN POST
