I get a real odd tool path with a left hand tool and back to front direction with rest enabled and angled lead ins. All but the last lead in ignores the length and goes to the Outer radius.
If I turn angled lead off it looks OK but there's no clearance, each pass starts on the material. File's attached.
Thanks Mark
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
@HughesTooling I am seeing the problem with the angled entry and I'll make a ticket for it. But I don't see the problem with the tool starting inside the material with angled entry turned off. The X and Z clearances seem to work as intended with respect to the rest material boundary. Or am I missing something here?
Akash Kamoolkar
OK I see if you zoom in there's a bit of clearance. Although the last pass starts touching.
Would be nice if you could have a distance you start off the stock. A bit like the Z clearance allows a bit more clearance off the front of the part.
Mark
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
The issue of angled entry being measured with respect to the stock limit instead of rest area limit was fixed in the update that recently went out.
Regards,
