Haas UMC - probing geometry fusion post error

[azjulian72]

Hi - I did not think this was a machine limitation...  But if I have a hole that is offset to the WCS, by B axis and C axis and I try to use tool orientation with my probe to pickup the bore geometry (I want to adjust my tool wear) I get this post error 

###############################################################################

Error: Your machine does not support the selected probing operation with DWO enabled.

Error at line: 2133

Error in operation: 'Probe Geometry2'

Failed while processing onCycle() for record 365.

[DanOMFG]

The Haas control does not support probing while using DWO.  

To get around this, create a new setup and set a different WCS with the machine in the proper orientation to probe your feature.

For example, machine your part using g54, then set a new datum for g55 on a finished surface of your part and run the the applicable probe cycle.  

[azjulian72]

thank you - appreciate the response