HAAS Post request

[Anonymous]

I'm looking to change the stock Haas Post to Use G95 for tap feed.

There are a few things in the below example. G95 before the G84 line output, and the feed for tapping now equals the tap pitch.  Advantage is if you change the S value, now you don't need to change the F in this case.

I'd also love to have a block Delete in front of the M8. Keeps me dry when part proving.  Also the end lines of the program in the format shown below would be most spectacular.

TIA

B-Mak

N23 G80
N24 G00 Z100.
N25 M9
N26 M01
N27 T20 M06 (#10-32 NF TAP 3/16 INCH)
N28 G90 G80 G40 G54
N29 S2006 M03
N30 G43 H20
N31 / M08
N32 G00 X-6.35 Y-8.89 Z100.
N33 G95
N34 G98 G84 Z-8. R2. F0.794
N35 X6.35
N36 G94
N37 G80
N38 G00 Z100.
N39 M9
N40 M01
N41 G28G91Z0
N42 G28Y0
N43 M30

[bob_holland]

@Anonymous,

Thank you for using Fusion 360 for your CAM needs.

For this type of question, you might want to send it to [email protected].

I will  bring this to their attention.

Thank you again for using Fusion 360.

[skidsolo · Accepted solution]

We can put this in your post as a property to use the thread pitch fro tapping. Please email [email protected], and we will change the post to suit your needs.