Haas GR 510 Gantry Mill Post Processor

[Anonymous]

I have a Haas Gantry Mill with the next gen controller.  I am using the generic post for the next gen controller.  What I would like to do is change the G53 Z 0 movements in the post to G53 Z4.  My home switch is actually not at the top of the stroke so anytime I go to a tool change it actually drops the tool down and causes a crash.  Also after the tool change i'd like for it to do the same thing so i avoid a crash as well. Thanks

[Boopathi_Sivakumar]

@Anonymous 

Please find the attached post processor, Check it for few operations before proceeding with the machine,

poke back if you have any doubts

Thanks,

Boopathi

[Anonymous]

Thanks a ton the program looks great.  One issue after the tool change it would be nice to do a G53 Z 4 if possible.  Thanks

[Boopathi_Sivakumar]

@Anonymous 

find the attached post processor 

Thanks,

Boopathi

[michaelgimbel72]

Please note that this post corrects the G53 G0 Z0. to G53 G0 Z4

This WILL cause a machine crash. Haas machines interpret this is Z0.0004

The correct replacement is G53 G0 Z4.0

[programming2C78B]

^That is a setting you can change on the controller for numerals without a decimal place.