G53 Z Retract is HAAS Turning Post turned off before tool change?

[ChevelleNV]

Can any one tell me why the the Z Retract in the "HAAS turning" post is commented out. I just had a program almost crash my machine because it only did a G53 X0 retract before a tool change. older programs from an older post always did a G53 X0. and G53 Z0. before a tool change.

I checked to make sure this wasn't something I did and digging through the latest downloaded copy of the post it has the z Retract commented out on line 785

[seth.madore]

The latest "Haas Turning" post processor is 120 days old, that's surprising. All the other Haas turning posts are 3 days old and do NOT have that same modification. I'll raise this with the post team.

I assume you've removed that "//" from the Z retract?

[ChevelleNV]

I did.....

luckily I caught it on the machine I was in 5% rapid. If I had not caught it it would have crashed my machine

[seth.madore]

😲