Fusion 360 simulator not cutting deep enough

[Killerpiraat]

Hello,

I am trying to make a design in Fusion 360, but when i simulate the cutout, my mill is not going deep enough to completely cut out the workpiece. It leaves .5mm of material, and thus doesnt fully cutout my piece.

This is the maximum depth the mill is going to. As you can see, its stops .5mm before the bottom (workpiece is 6mm thick)

What am i missing here?

[seth.madore]

Can you export and share your Fusion file?
File > Export > Save to local folder, return to thread and attach the .f3d file in your reply

[Killerpiraat · Accepted solution]

It was the stock to leave box. Apologies 🙂

[seth.madore]

Ah yes, that will do it!