Fanuc Post End of Tool End of Program Change

[Anonymous]

New poster casual user of 360 here. Longtime going back 40 yrs and 7 other cam programs and post editor user.   Have always managed to slog thru other post processors and got what I needed however the 360 post are difficult to wade thu.   

If someone could help with this I may be able to make the other changes once I can trace it back.   

My end of program from the standard  fanuc (nothing else) post  looks like the below. Lines 38 through 44.

What I need and want is shown in line 47-50 plus the percent. 

If anyone could document or point me in the best direction. Do not have aLlot of time to learn java or hack away till I get the needed result I think I could take off and run with the other changes I need. 

thanks

Larry 

Condor Tool and Mfg. Inc. 

CODE

[daniel_lyall · Accepted solution]

grab the post-editing program here https://forums.autodesk.com/t5/hsm-post-processor-forum/autodesk-hsm-post-editor-for-visual-studio-c...

[Anonymous · Accepted solution]

This worked well. After an hour of review and install got my first two lines of code changed.  Was even easier than some of my other cam systems.  The extension that runs in Visual is a game changer.  Thanks much.