Even if you change the wcs output settings in the wcs location settings, g54 does not change.

[Unixprocessing]

I understand that if the wcs output setting is set to 3, nc data should be output through g56.

As shown in the picture, nc data is output to g54. Do you know what the solution is?

[a.laasW8M6T]

Hi

Are your sure the output file is being over written?

What happens some times is the file doesn't update in VS code(if you have made an edit to it) and it keeps showing the old version

Try exiting out of VS code and then opening the file again

[Unixprocessing]

This has been going on for several days. It's the same even if you open the file after quitting.

[a.laasW8M6T · Accepted solution]

But you have successfully changed WCS in the Past?

What Post processor are you using? it could be an issue introduced in a recent update.