Doosan VMC 3/5 Post issues

[tjolley_]

I am not post editor, I have attempted to edit the Post following some instruction on here.

The problem is the post is posting the A axis in the wrong direction. I need it reversed from the default. My 4th Axis is facing X- . The post seems to be posting with it facing X+

the instructions i found do not seem to work or i am missing something changine the 1 to -1 save on my desktop i import it and repost nothing is different. 

[scottmoyse]

Doosan actually have a heap of variation within each model... depending on how the MTB or Vendor configure the machines on delivery. 

Give this post a trial and see if it does what you need. I've set it up for a number of my Doosan VMC customer with 4-axis rotories. https://massif.dev/post-processors/doosan-vmc-with-4-axis

[tjolley_]

thank you but this did not seem to work. i got a posting error when i tried to post the same program

[scottmoyse]

What was the error? And can you share the Fusion 360 file you are trying to post process?

[tjolley_]

i would rather not.

it posts fine with the generic post the A axis needs to be reversed 

[scottmoyse]

Irrespective of the post you use... you need to supply examples and clear descriptions of errors for people to help you.

All the best.

[tjolley_]

this is the error i get when i use the post you provided. 

if i use the generic post. it works fine other than the A axis is reversed 

[scottmoyse]

The attached file outputs without error using that Massif post...

Reading that error, it looks something at the end of one of your toolpaths is causing it. 

In any case, the attached file has a machine configuration within it, which the Setup uses. 

This is the old UI for machine config, but this is where you would switch between the 1 & -1 in this case... in the new UI it's not as abstract.