I have an issue with my machine orientation when posting to my Shopsabre WINCNC machine. I do not have this issue when posting to my Carbide 3D machine. In the picture below, you can see the x-axis and the y-axis rotated 90 degrees around the z-axis when compared to the navigation cube. What setting do I need to change to orient the machine correctly?
Why do you need to do that? You can just change the alignment of the part in the Setup.
If it's a visual thing you're after, you'd have to edit the Machine configuration file (using Machine Builder) and rotate your machine components around the Z axis.
The simple answer is time. I may put a dozen panels on my machine a day. I am using fusion to simplify and streamline my process. I may put a dozen panels on my machine a day. When I enter the manufacturing space, I need to select the x-axis and the y-axis when I enter the manufacturing space. If my drawing is always at 0, 0, 0 aligned with the x and y axis, it seems reasonable that I should be able to have these entries in my setup,
versus
If I need to edit the design for any reason, I will need to reselect the X and y axis.
Then you're going to have to edit your Machine Configuration (in the Machine Builder) to reorient your machine to the preferred alignment.
One observation though; you mentioned that it's rotated 90 degrees from the navigation cube. It's not though, is it?
Could you share a sample file where this misalignment is better shown?
