CoroPlus Tool Library Error: Parameter validation

[noakes_eng]

Dear Forum,

Using the CoroPlus tool library, select the assembly button and build a tool assembly from within the tool library. I receive the following issues.

I am new to the Coroplus tool library and am unsure where the issue lies.

Error: Parameter validation

Shoulder Diameter must be positive and non-zero!

Kind regards,

Oliver Noakes

[programming2C78B]

And how does it look in the Shaft tab?

[noakes_eng]

Hello, 

Please see attached.

[seth.madore]

Is this a tool from the Vendor Libraries or are you using an addin or some means of importing a tool?

[noakes_eng]

@seth.madore These are the values that came with the tool from the CoroPlus tool library, when click send to fusion.

[seth.madore]

Unfortunately, this is an issue with the addin, not Fusion. It would fall to Sandvik to correct the issue 😞

[noakes_eng · Accepted solution]

I have had word from Sandvik, fault is known and there will be a fix shortly.