Constant Toolpath generation

[ICanSpinIt]

There was an update a long time ago where the Toolpaths would start automatically regenerating if one operation was changed. It started bogging down the computer. I dealt with it until now! I have about 100 operations that are trying to regenerate if I make a change to 1. Its freezing everything up. 

I have unchecked both of the boxes in the prompts under the manufacturing settings. It still goes crazy

How do I get this auto generate issue to stop?

[Tom.Hemans]

Hi @ICanSpinIt,

You can Protect toolpaths (right click on the toolpath in the Browser and select Protect) to stop it from being recalculated.

Hope this helps,

Tom

[HughesTooling · Accepted solution]

Have you disabled in process stock generation?

[ICanSpinIt]

The tool paths were all locked and it would still re-generate. The answer below solved the issue. Thank you for replying

[ICanSpinIt]

Took me about 10 minutes for the computer to allow me to un-check it, but that solved the issue. I have a fast computer again!! Thank you