Part A (toolpath as expected):
Part B (not as intended):
Chris cross pattern toolpath coped from Part A setup:
- Home
- >
- Product Design & Manufacturing
- >
- Fusion Forums
- >
- Manufacture Forum
- >
- Chris cross pattern caused by leads
Chris cross pattern caused by leads
Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
Chris cross pattern caused by leads
Advisor
165 Views
1 Reply
166 Views
1 Reply
Reply (1)
Message 2 of 2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
You get this behavior only with stock contours turned on, Obviously if you turn it off there will be a massive amount of air cutting.
If you turn off the lead-ins in the linking tab it will fix this issue, however you cannot use In control cutter comp with this method.
(If you needed to use cutter comp you could run two separate 2D contours, one to machine the flat surface, with radial stock to leave, and another just to finish the wall of the part with cutter comp turned on)
