Can't add Post Processors - not showing up

[Anonymous]

Hi all,

I am struggling to add Mach3 Turning Post processor to the cloud.

I downloaded it, opened A360 Drive, there were no folders so I created a CAMPosts folder and put in mach3 turning.cps and... nothing on the fusion 360. Selecting My Cloud Posts I have "No Posts Are Available".

Any clue on what I am doing wrong?

Thanks!

[HughesTooling · Accepted solution]

The posts are not stored on 360 drive anymore. Go to your preferences and make sure cloud libraries are enabled, then in Fusion's Data panel look for the Assets project at the top level. In the assets project you should find the CAMPosts folder.

Take a look through What's new in the link below for more info

http://www.autodesk.com/products/fusion-360/blog/january-19-2017-update-whats-new/

Mark

Edit Assets Project.

[LibertyMachine · Accepted solution]

And since I'd rather not waste the use of a good screencast:

[Anonymous]

Gosh! I wish there was not so much misinformation on line!

Thank you all!

[maker9876]

It would be smart if the F360 team put a message in the A360 / Cam Posts folder which they've left presumably so that people don't lose information that they stored there.

I only just spent half an hour trying to figure out why it (a system that itself was quite new) didn't seem to be syncing - thank heavens for this forum post.

Delighted with the pace of progress! 😉

[Anonymous]

You Sir, have saved my behind. Thank you.