Camplete ignores pass throughs

[da_fish]

On 6/26/2020 Fusion added support for manual nc in the camplete post processor, however I am not able to get the passthrough to work. It posts out in the apt file like this:

CSI_INSERT_CUSTOM_GCODE/M0(Flip Part)

but camplete completely ignores it. I don't know if the post is formatting it wrong or if I need to change a setting in camplete. Any help appreciated, Thanks 

[jmeyette]

You would need to add an Insert Custom GCode New Code to the sections of code you may want that output (i.e. Start Program Block, Tool Change Block, 3+2 Block, etc...)