Bug: Fusion 360 drill pattern ignoring selected depth on some holes

[nmorong]

See attached screenshot. There are 12 holes, and for 2 of them fusion is ignoring the selected bottom height. This is for a spot drill operation, the half cylinder cutout has not been machined yet. I'm trying to use a drill to remove most of the material in the cutout, and am trying to spot all my holes at once to save a tool change.

Just another bug that could break tools and scrap parts to be aware of.

[difalkner]

You're probably going to have to upload the *.f3d file.

[nmorong]

No, I'm not uploading my file. The screenshot shows the entire issue. I know exactly what the problem is and I wasn't asking anyone to figure this out for me. I posted as a warning to others that fusion will ignore a selected hole depth in some circumstances.

The top height was by default the hole top. Unless I change this as well, rather than giving an error message or not generating a toolpath for those holes, fusion ignored my input and generated a toolpath for those 2 holes that started below my selected bottom depth. A toolpath should NEVER, IN ANY CIRCUMSTANCE, exceed the selected bottom depth. This is dangerous.

[seth.madore]

---

@nmorong wrote:

No, I'm not uploading my file.

---

Without seeing more of your file and your settings, it's not going to be feasible for us to file a ticket to get this looked at.

I understand that you may not want to share it publicly, but can you share it privately?

Email it to me at: seth DOT madore AT autodesk DOT com