Attached is a part where I have two 3D Adaptive Clearing operations. The Fine Step down in both are equal to the Maximum Roughing Step Down(1.25). I don't what any fine step downs.
In the first operation, everything works fine.
But if I turn on flat area detection it suddenly wants to do fine step downs as well. I seems like the fine step down amount is somewhat connected to the Minimum Step down amount but not totally. Again, The fine step down amount is equal to the Maximum roughing step down(1.25) so I don't know where it gets the notion to create these small step downs.
I have all preview flags turned off.
Thanks in advance!
