Community
Fusion Electronics
Working an electronics project and need help with the schematic, the PCB, or making your components? Join the discussion as our community of electronic design specialists and industry experts provide you their insight and best practices.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

tRestrict areas belonging to footprints are ignored during ratsnests

5 REPLIES 5
Reply
Message 1 of 6
segreteria9R6B8
278 Views, 5 Replies

tRestrict areas belonging to footprints are ignored during ratsnests

Hi everyone

I designed a board in Eagle and opened it with Fusion 360. 

I immeadiately noticed a difference in polygon fill as the tRestrict areas belonging the component's footprint are not respected and thus overridden.

In the picture below you can see how the exact same component connected to GND plane in two different ways.

 

 

Eagle_tRestrict.PNGFusion_tRestrict.PNG

 

Funny enough, if i manually draw a tRestrict line in Fusion and place it near the footprint the problem doesn't go away.

Fusion_tRestrict_line.PNG

 

Thanks in advance for your replies

5 REPLIES 5
Message 2 of 6

Hi @segreteria9R6B8,

 

Would you be able to share the library? If not could you copy that specific component to a new library and send it to me. I would like to pass it along to our developers for review. I don't know which picture is which but the correct one is the one that only has one spoke connecting to the pad.

 

Thanks in advanced for the component.

 

Let me know if there's anything else I can do for you.

 

Best Regards,



Jorge Garcia
​Product Support Specialist for Fusion 360 and EAGLE

Kudos are much appreciated if the information I have shared is helpful to you and/or others.

Did this resolve your issue? Please accept it "As a Solution" so others may benefit from it.
Message 3 of 6

Hi Jorge,

here is the library with the two components I'm facing problem.

Concerning my previous post, first picture is from Eagle, secondo from Fusion.

Regards

Message 4 of 6

Hi @segreteria9R6B8,

 

I hope you're doing well. Thank you for the library. I will pass this along to the developers in the ticket I created.

 

Let me know if there's anything else I can do for you.

 

Best Regards,



Jorge Garcia
​Product Support Specialist for Fusion 360 and EAGLE

Kudos are much appreciated if the information I have shared is helpful to you and/or others.

Did this resolve your issue? Please accept it "As a Solution" so others may benefit from it.
Message 5 of 6

Hi @jorge_garcia 

 

Are there any updates concerning this topic?
It is becoming very urgent on my side.

Thanks

Message 6 of 6

Hi @segreteria9R6B8,

 

I hope you're doing well. This issue has been bumped up and a developer is looking into it to fix it.

 

Let me know if there's anything else I can do for you.

 

Best Regards,



Jorge Garcia
​Product Support Specialist for Fusion 360 and EAGLE

Kudos are much appreciated if the information I have shared is helpful to you and/or others.

Did this resolve your issue? Please accept it "As a Solution" so others may benefit from it.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums