Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Strange looking pads in 3d view

Anonymous

Strange looking pads in 3d view

Anonymous
Not applicable

Hello,

I have done footprint & 3d package via creator. Could you please prompt me what are these brown stain surrounding every pad? This thing is irregular and simply it doesn't look good. Another question is if there is any option to set resolution of silkscreen ? Sometimes resolution of elements descriptors is very low, sometimes it's fine. Thank you in advance

boncz3k_0-1606254212355.png

 

0 Likes
Reply
286 Views
1 Reply
Reply (1)

jorge_garcia
Autodesk
Autodesk
Hi @Anonymous,

I hope you're doing well. That brown is the substrate where there is no soldermask. There is currently no controls for adjusting the resolution of the silkscreen.

Let me know if there's anything else I can do for you.

Best Regards,


Jorge Garcia
​Product Support Specialist for Fusion 360 and EAGLE

Kudos are much appreciated if the information I have shared is helpful to you and/or others.

Did this resolve your issue? Please accept it "As a Solution" so others may benefit from it.
0 Likes