Problems Importing DXF to PCB

[Anonymous]

When I try to import a DXF file (using import-dxf.ulp) into my PCB design, I get a "Can't find 'dxfimp.scr' error every time.    After an exhaustive internet search, I cannot seem to find a solution to this problem.   Has anybody else encountered this problem?

[Jeff_Birt]

You have to save the board file before it will let you run the importer. Also make sure you turn of the 'Push Validators' or it will likely leave out portions of what you are trying to import.

[ciaran.dowds18]

I'm also having problems importing a very simple one layer dxf into fusion 360 PCB software. I just get a failure error. All files were saved. Not sure how to turn off push settings, if that's still necessary? File is attached. Thank you.

[panpan_fan]

Hi @ciaran.dowds18 @Anonymous 

I hope you are doing well!

In Fusion 360 Electronics, we have the Insert DXF/DWG command.

I try the dxf file using the command and I can insert it successfully.

Would you mind having a try? Thanks!

Regards,

Panpan Fan