Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

pcb panel in fusion 360 Electronic

anuradha.bodke
Advocate

pcb panel in fusion 360 Electronic

anuradha.bodke
Advocate
Advocate

Hello Team 

I  am using fusion 360 Electronic ,

Trial board file created & I want pcb panel how to do it in Fusion 360 Electronic 

Please reply

 

Thanks In Advance

 Anuradha Bodke

0 Likes
Reply
1,119 Views
1 Reply
Reply (1)

jorge_garcia
Autodesk
Autodesk
Hello @anuradha.bodke,

I hope you're doing well. Panelization is not currently available in Fusion360 Electronics, there is some experimental development going on to make it happening but it has yet to bear fruit.

For now your best approach is going to be to try to panelize the 2D PCB following a similar procedure to EAGLE. Run the panelize ULP and then make as many copies of the board as you need.

Let me know if there's anything else I can do for you.

Best Regards,


Jorge Garcia
​Product Support Specialist for Fusion 360 and EAGLE

Kudos are much appreciated if the information I have shared is helpful to you and/or others.

Did this resolve your issue? Please accept it "As a Solution" so others may benefit from it.
0 Likes