Copy tool does not mark the document as "dirty" (save required)

[rbeyerCLBSZ]

Copying any element in a schematic does not seem to mark a document as "dirty" (the save-required flag is not set). This works on any copied element (even if you edit the element). For example if you copy a TEXT element, then change the text, the document does not show up as "save required". The flag (the "*" in the name at the top of the screen) doesn't change until you switch to a different document.

[rbeyerCLBSZ]

It may be a little worse than just the Copy tool, it seems like any change I make (now that it's been open for a few hours) doesn't set the document as dirty.

[jorge_garcia]

Hello @rbeyerCLBSZ,

I can't reproduce this. Could you try with another Fusion360 design? I'm trying to figure out if there is something unique about your design. Also make sure to update your Fusion we released a hotfix this week to address some saving issues and this may be related.

Let me know if you continue to run into problems.

Best Regards,