Bug: Corrupt file when pushing to fusion

[a.skala]

Hello,

I often face issue with Fusion and Eagle. When I try to push a board changes from Eagle to Fusion, it some times fail. Push in eagle ends with successful message, but when I try to open board in Fusion, I get this error:

I always have to unlink board in Eagle and push it under a new name, remove old from my assembly and add a new to it.

Opposite direction works always.

Fusion360: 2.0.10806

Eagle: 9.6.2

[a.skala]

Another kind of message box when file is corrupt.

[a.skala]

Now I also get pdf generated in folder where I push with name of Design and  `_errorReport.pdf` with content:

Only way to overcome is to unlink design and link it in new file in Eagle.

[panpan_fan · Accepted solution]

Hi @a.skala 

I hope you are doing well!
Sorry to hear that you can't do Fusion Sync successfully.

Would you mind sending me your brd file to have a look? We think the translator error may be related to your file.

I will send my email address to you as a private message.

Regards,

Panpan Fan

[JuergenGe · Accepted solution]

I have the same issue with several files.

Is there a general solution to this?

[panpan_fan · Accepted solution]

Hi @JuergenGe 

I hope you are doing well!

Would you mind sending me your files to check?

I will send my email address to you as a private message.

Regards,

Panpan Fan

[a.skala]

Hello @panpan_fan, email sended.