Zoom opposite direction

Zoom opposite direction

andreas.steffek
Explorer Explorer
1,195 Views
2 Replies
Message 1 of 3

Zoom opposite direction

andreas.steffek
Explorer
Explorer

I just noticed that when scrolling down in the PCB design view I'm zooming out, but when switching to the 3D view I'm zooming in! That's very irritating and I don't think it has always been this way, is there something wrong with the latest update?

0 Likes
Accepted solutions (1)
1,196 Views
2 Replies
Replies (2)
Message 2 of 3

jorge_garcia
Autodesk
Autodesk
Accepted solution

Hello @andreas.steffek,

 

I hope you're doing well. That's how it's always been I didn't notice it until you just brought it up. 

 

If you go into preferences, General. You'll see the option to reverse zoom direction. That will apply to the modeling environments of Fusion 360. If you want to change it for electronics go to preferences > Electronics for the mouse zoom factor make the number negative. You only want to make this change for one or the other, don't do both.

 

Let me know if you continue to run into problems.

 

Best Regards,



Jorge Garcia
​Product Support Specialist for Fusion 360 and EAGLE

Kudos are much appreciated if the information I have shared is helpful to you and/or others.

Did this resolve your issue? Please accept it "As a Solution" so others may benefit from it.
Message 3 of 3

andreas.steffek
Explorer
Explorer

Thank you very much @jorge_garcia, that solved the problem! 

0 Likes