tRestrict areas belonging to footprints are ignored during ratsnests

[segreteria9R6B8]

Hi everyone

I designed a board in Eagle and opened it with Fusion 360. 

I immeadiately noticed a difference in polygon fill as the tRestrict areas belonging the component's footprint are not respected and thus overridden.

In the picture below you can see how the exact same component connected to GND plane in two different ways.

Funny enough, if i manually draw a tRestrict line in Fusion and place it near the footprint the problem doesn't go away.

Thanks in advance for your replies

[jorge_garcia]

Hi @segreteria9R6B8,

Would you be able to share the library? If not could you copy that specific component to a new library and send it to me. I would like to pass it along to our developers for review. I don't know which picture is which but the correct one is the one that only has one spoke connecting to the pad.

Thanks in advanced for the component.

Let me know if there's anything else I can do for you.

Best Regards,

[segreteria9R6B8]

Hi Jorge,

here is the library with the two components I'm facing problem.

Concerning my previous post, first picture is from Eagle, secondo from Fusion.

Regards

[jorge_garcia]

Hi @segreteria9R6B8,

I hope you're doing well. Thank you for the library. I will pass this along to the developers in the ticket I created.

Let me know if there's anything else I can do for you.

Best Regards,

[segreteria9R6B8]

Hi @jorge_garcia 

Are there any updates concerning this topic?
It is becoming very urgent on my side.

Thanks

[jorge_garcia]

Hi @segreteria9R6B8,

I hope you're doing well. This issue has been bumped up and a developer is looking into it to fix it.

Let me know if there's anything else I can do for you.

Best Regards,