Selecting airwires

[mike.durian]

When did the ability to select airwires disappear and was it intentional? I'm just noticing it now. Being able to select an airwire to determine the coordinates of the endpoints is very useful when you want to fine-tune off-grid placement. It is also handy when you want to use the Show command to highlight the endpoints. When you have a number of airwires with roughly the same endpoints, it is sometimes difficult to distinguish them.

[panpan_fan · Accepted solution]

Hi @mike.durian 

I hope you are doing well!

We don't make Airwire selected by default in the Selection Filter recently to help the users move components easily.

If you want to select Airwire, please select it in the Selection Filter panel.

Regards

Panpan Fan

[mike.durian]

@panpan_fan ,

Thank you. While I checked to see if this was a preference setting, I did not think to look at the selection filter (and I should have).

[sergeQJMQW]

Finally, I found it! Please make it default. Or memory of this selection. Thank you!

[sergeQJMQW]

Finally, I found it! Please make it default. Or memory of this selection. Thank you!