Improvement suggest - faster switching between commands, when using keyboard shortcuts

[D-NGK]

I am not sure this is a problem on my side. But it seems not, as the speed is roughly the same between my workstation and my mobile unit.

During fine tuning a design, I need to switch often between "rip-up", "route" and "move".

While the commands having a shortcut is already much more intuitive and convenient then in eagle times (There, I used "alt+..." shortcuts) it takes a significant time to switch.

In average about 1 - 2 seconds (enough to interrupt a smoot workflow) and sometimes more.

Additionally, the command is not always registered, which is an additional interruption to the workflow as I push sometimes, wait but it not pops up.