Electronic Design shows thumb nail of Schematic but Schematic is completely blank

[Anonymous]

I don't know how this happened. My electronics design liked to the schematic shows my hard work in the thumbnail of the schematic linked to it, but when I open the schematic it appears blank as if it was a brand new schematic design. I have tried changing versions and I can only open versions from 3 or 4 version ago.

[panpan_fan]

Hi @Anonymous 

I hope you are doing well!

So sorry to hear that. Would you mind inviting me into your project to have a look?

I will send my email address to you as a private message.

Regards,

Panpan Fan

[panpan_fan · Accepted solution]

Hi @Anonymous 

Thank you so much for your information! 

As I mentioned in our conversation, the reason for this issue is that there is empty space in the attribute name.

I have reported this issue to our develop team and I will keep you updated when we fix this issue.

Regards，

Panpan Fan

[Anonymous]

Thanks very much for your help with that one Panpan Fan. It left me stumped. Turns out if you double click on the attribute name in the attribute name and values window on the left of the UI you can then change the name and it actually lets you add spaces whilst you couldn’t when initially creating the name in the box below. 

[panpan_fan]

Hi @Anonymous 

Thanks again for reporting this issue to us!

So far, we find that the colon in Net name and Device name will cause same issue. Beside, the semicolon in attribute name will has same problem. Before we fix them, please do not use those special characters in case it cause the blank schematic issue again.

Regards,

Panpan Fan

[panpan_fan]

Hi @Anonymous 

I hope you are doing well!

Today we release Fusion 360 V2.0.10940 and the special characters issue has been fixed. We will not allow the special characters to avoid the blank file issue. If you still meet any blank schematic issue, please let us know. Thanks!

Regards,

Panpan Fan