Volume calculation error
The volume of your container is 1.458 liters. In the attached model, the body labeled "Volume" is the one to measure.
John Hackney, Retired
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
You must have attached a different model because the link you gave only measures approx 101.0 x 101.0 x 150.5 mm. Of course it has some form in one end that will reduce its volume. I suggest that you go back to your post and open the model you gave in the link to and try again.
John Hackney, Retired
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
The reason for your difficulty in using a Boundry Fill is because the model body, which you created from the surface model, has holes in it. The surface body has the original holes so the body will also. Take the model I am returning, do a stitch on it, selecting the main surface and the neck boundry fill I placed, and you can see the problem areas in red.
John Hackney, Retired
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
I took a few minutes to repair your surface model, create a new solid, and using a bit different method than Boundry Fill, I have determined the interior volume. This is "right to the top" of the neck. It is:
Corrected model is attached. Take a look at the Volume Body and the Bottle Body to see the difference.
John Hackney, Retired
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
