Unjoined faces

[Anonymous]

Hello,

I can't join the two faces of one bodie (the one in red and the one in green). This line prevents me to draft the surface. I think this is not due to an angle defect because the faces seem coplanar.

If someone could help me I would be greatful.

Theophile

[TheCADWhisperer]

---

@Anonymous wrote:

I think this is not due to an angle defect because the faces seem coplanar.

Faces not co-planar.

[Anonymous]

Thank you for your reply. I saw that too but i didn't find the reason of this non coplanarity. so i thought it was an aproximation failure. If you know why there is an angle it would help me a lot.

Thanks, théophile

[TheCADWhisperer · Accepted solution]

I didn't see the cause, but I can tell you that I would start over from scratch if it were my model.

I think you can significantly simplify the modeling steps.

[TheCADWhisperer · Accepted solution]

I experimented a bit (see Attached).

[Anonymous]

Hello the cad whisperer

Thank you very much for your quick reply, it helped me a lot.

sincerly yours