Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Unable to remove single edge from multiple fillet feature (bug!?)

4 REPLIES 4
Reply
Message 1 of 5
edwinATABC
676 Views, 4 Replies

Unable to remove single edge from multiple fillet feature (bug!?)

After creating different fillets on multiple edges in one single fillet feature, I tried to remove one, which results in all fillets becoming 0! This looks like a bug.

 

It used to be possible to remove one (or more) edges, by holding ctrl/command and selecting the edge.

 

Replicating:

 

Draw a box, click fillet, make 2 edges R1 and 2 other edges R2, finish

Now try to edit the fillet feature: hold ctrl and de-select one of the edges: immediately after de-selecting, ALL radii become 0 (and if you have multiple entries, they all become one)

 

Note: I run a Mac (in case it is relevant)

4 REPLIES 4
Message 2 of 5
g-andresen
in reply to: edwinATABC

Hi,

I think this topic was also covered here

 

günther

Message 3 of 5
edwinATABC
in reply to: g-andresen

I didn't find that one, but yes, it is the same thing.

 

And it is worse when you have multiple radii, because then you cannot simple re-enter the radius, as it throws all radii on one heap...

 

Is there be a bug report somewhere, or should I make one? (don't know how this works with F360)

Message 4 of 5
g-andresen
in reply to: edwinATABC

Hi,


@edwinATABC wrote:

 

Is there be a bug report somewhere, or should I make one? (don't know how this works with F360)


In that thread # 2 from

@jeff_strater 

 

günther

Message 5 of 5
edwinATABC
in reply to: g-andresen

Ah thanks, now I see, I didn't scroll below the blank area, so I only saw the post itself.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report