Unable to remove single edge from multiple fillet feature (bug!?)

edwinATABC
Contributor
Contributor

Unable to remove single edge from multiple fillet feature (bug!?)

edwinATABC
Contributor
Contributor

After creating different fillets on multiple edges in one single fillet feature, I tried to remove one, which results in all fillets becoming 0! This looks like a bug.

 

It used to be possible to remove one (or more) edges, by holding ctrl/command and selecting the edge.

 

Replicating:

 

Draw a box, click fillet, make 2 edges R1 and 2 other edges R2, finish

Now try to edit the fillet feature: hold ctrl and de-select one of the edges: immediately after de-selecting, ALL radii become 0 (and if you have multiple entries, they all become one)

 

Note: I run a Mac (in case it is relevant)

0 Likes
Reply
681 Views
4 Replies
Replies (4)

g-andresen
Consultant
Consultant

Hi,

I think this topic was also covered here

 

günther

0 Likes

edwinATABC
Contributor
Contributor

I didn't find that one, but yes, it is the same thing.

 

And it is worse when you have multiple radii, because then you cannot simple re-enter the radius, as it throws all radii on one heap...

 

Is there be a bug report somewhere, or should I make one? (don't know how this works with F360)

0 Likes

g-andresen
Consultant
Consultant

Hi,


@edwinATABC wrote:

 

Is there be a bug report somewhere, or should I make one? (don't know how this works with F360)


In that thread # 2 from

@jeff_strater 

 

günther

0 Likes

edwinATABC
Contributor
Contributor

Ah thanks, now I see, I didn't scroll below the blank area, so I only saw the post itself.

0 Likes