Trying to make half a funnel with a wall, and a threaded bottom

[luke_beames]

Thanks in advance for any help!

I have watched hours and hours of tutorials but am still struggling with my design. Still have lots to learn, but was hoping someone would have some pointers as to accomplish the following: 

- A funnel that is flat on one half (as to be able to be pressed flush against a flat service) 

- The bottom of the funnel threaded so that I can screw the funnel onto a plastic bottle 

- On the flat half of the funnel, I'm wanting to design a bit of a lip (think the end of a dust pan) so that when the funnel is flush against a flat service, liquid will be better directed through the funnel 

Any help is appreciated. In the mean time, i will keep watching tutorials. Thanks again! 

[davebYYPCU]

You will need the thread details, 

To fill the bottle or empty it?

Sounds like a bottle adapter for empty routine, but.... Doable...

Might help...

[g-andresen]

Hi,

have a look

You would have to insert the thread as a custom thread if it is not available in Fusion.

günther

[luke_beames]

It is to fill the bottle, though in most cases the bottle will only become max 1/3 full. 

[luke_beames]

You are AMAZING!! Thank you so much for taking the time to do that. I really, really appreciate it!!

[davebYYPCU]

Thread ?? goes on here.

Might help....