"Vertices" not connected when creating fillet

[ttotsbarc479HK]

I just started learning how to use this software this weekend...
I am trying to create a fillet along this edge but when I do the "vertices" separate at the point where they are connected. Any idea why this is?

[laughingcreek]

try using cord length-

[ttotsbarc479HK]

Thanks for your advice...

That helped alleviate the issue quite a bit, but there are still points that are disconnected.

To create this large body/piece I had used a "Loft", perhaps that somehow cause the points to not merge for some reason..?

[g-andresen]

Hi,

Please share the file for reply.

File > export > save as f3d on local drive  > attach to post.

günther

[ttotsbarc479HK]

Hey there,

Attached here is the exported file.

I attached two files:
-First is without the fillet, so you can see it before the fillet was used.
-Second is with the fillet.

One thought I had is that my object is very small...could that be causing the issue?
Also, as a side note...I might be approaching this form the wrong way, maybe there is an easier way to create that piece without using a "loft" on that top gentle arch.  Since I'm new to the tool, I a loft seemed like the best approach. 🙂
 
Thanks for taking a look.

[TheCADWhisperer]

I recommend that you start over and enable Capture Design History.

[davebYYPCU]

Plain and simple geometry.

Measure the angles at each pair of faces.

The same fillet size dictates that the tangent connections must separate.

Might help…

[ttotsbarc479HK]

Thanks all for your suggestions...Ill try starting over and using some of that advice plus some other stuff I have found online,

Ill report back if things work out 🙂