Pyramid type shape ?

[Anonymous]

I seem to not be able to create a Pyramid type of shape. The shape I'm trying to make is a "Hip" roof, not the construction just a basic block shape. Any suggestions ?

[HughesTooling]

Draw a rectangle and extrude tapered, the taper option doesn't show until you start to extrude.

Mark

[Anonymous]

Awesome, thank u.

[JDMather]

See attached.

[I_Forge_KC]

If you want different tapers on the two sides, try something like this...

Note: There are better/faster ways to constrain your geometry if you want the mid-point snap like I did there, and the extrude cut is better done with through-all instead of a distance.

[Anonymous]

Thanks again.

I_Forge_KC, I thought of doing it like that to begin with and shall keep it in mind, I'm still curious what exactly can be done in F3D.

[HughesTooling · Accepted solution]

Here's another way using draft, you could use more than one draft feature if you needed different angles on some sides.

Mark