Problem with unwanted edge on face/body

[fyrisk]

Hello,

I started using Fusion 360 few days ago, went trought many tutorials but I couldn't find answer for my problem.

How to delete the egde in front of my model?

I want to design stipes on this vase look like form and every time I split face with my stripes, this edge combines with one stripe.  

How to deal with it? 

Thanks everybody 😉

[fyrisk]

so then I cannot pull this one, uh

[TrippyLighting]

Could you share the model ?

I would try to delete that split surface and then loft a new one back in. That, however might not recreate the curvature of the original surface. Hard to say.

[fyrisk]

Thank you very much

[TrippyLighting]

Thanks, but I really need the model wit all the ribs/grooves as shown in your screenshots.

[fyrisk]

ahmm, okay!

[fyrisk]

How is it going? Any help m8? I tried to make it in other way but problem still exist. 

[TrippyLighting]

This is a situation where you need to move from solid modeling into the Patch workspace.

A little patching and lofting gets this done.

[fyrisk]

wow, what a nice solution. Thank you very much!

[TrippyLighting · Accepted solution]

Could you accept my last reply as the solution ?