problem with spiral cone not being flush

meisterpumpernickel
Contributor

problem with spiral cone not being flush

meisterpumpernickel
Contributor
Contributor

Hi everybody i created a design with a cone spiraling. my proble is that the end is not flush (see screenshot) does anybody have an idea how to solve this? 

0 Likes
Reply
412 Views
6 Replies
Replies (6)

mango.freund
Advisor
Advisor
are you sure that your axis is perpendicular to the part? did you use a small angular offset?
0 Likes

meisterpumpernickel
Contributor
Contributor

hi thanks for looking into it. i am not sure i understand your question. Do you mean the axis of the viewpoint, where i did the screenshot? The view is from an slight ofset angle.

0 Likes

mango.freund
Advisor
Advisor
Correction, after thickening the wall thickness * 2 indicates the offset. the outside edges are the same length. the inside edges are shortened by the incline
0 Likes

mango.freund
Advisor
Advisor

Unbenannt.PNG

0 Likes

mango.freund
Advisor
Advisor

Unbenannt.PNG

0 Likes

meisterpumpernickel
Contributor
Contributor

thank you. is there any way to avoid this or correct this?

0 Likes