object snaps for push/pull and extrude

[Anonymous]

when using PUSH/PULL in Sketchup it is always looking for a snap point or edge.  I am not seeing this at all with Fusion.  perhaps my settings aren't correct.  all the tutorials seem to be dimension based.  if I push a face back and want it to, say, be flush with an adjacent face it appears that I must either already know the exact displacement or simply eyeball it.  is this true?

[Anonymous]

when using PUSH/PULL in Sketchup it is always looking for a snap point or edge.  I am not seeing this at all with Fusion.  perhaps my settings aren't correct.  all the tutorials seem to be dimension based.  if I push a face back and want it to, say, be flush with an adjacent face it appears that I must either already know the exact displacement or simply eyeball it.  is this true?

[HughesTooling]

Start pushing or pulling then pick the face you want to be flush with. With extrude under extents there's an option "To".

Mark

[HughesTooling]

Start pushing or pulling then pick the face you want to be flush with. With extrude under extents there's an option "To".

Mark