Non-Circular Flat Wireless Charging Coil Modeling Help Needed

[ottomated]

Hello All,

I am trying to model a non-circular flat coil designed for wireless charging around this ferrite base design. All the custom coil/spiral tutorials I have seen online are 3 dimensional coils that resemble shocktower springs.

I an an intermediate designer on Fusion but would greatly appreciate any clues, work flows etc that would help me accomplish this task.

Thank you!

Best Regards

Otto

[jhackney1972]

Do you have a picture of what the Coils look like applied to your model?

[ottomated]

Sure thing; it looks like this but one side of the coil is completely circular

 

[laughingcreek · Accepted solution]

the process used in the attached model might get you there.

[kacper.suchomski]

👏👏👏

[ottomated]

Thank you so much @laughingcreek! I had alot of fun selecting 68 different profiles click by click to project the spiral pattern on my Sketch3 🙂

[laughingcreek]

---

@ottomated wrote:...I had alot of fun selecting 68 different profiles click by click to project the spiral pattern on my Sketch3 🙂

---

project the face, then delete the 2 lines you don't need.

[ottomated]

oh my god you are totally correct! thank you so much @laughingcreek