New to Fusion - Help on embossing please

[aldariondb]

I am new to Fusion and need help please. I created the body using revolve and trying to emboss the sketch on it. I get the following message: 

Cannot emboss near some features.

There are some features, voids, or holes on the selected face in the target area that prevent the emboss.

Can you please advise what I need to do? Thanks.

[johnsonshiue]

Hi! This seems like a bug or a limitation. The Emboss failure is related to the bigger circle (diameter 6mm). The circular profile sits across two different target faces. It seems that Emboss does not like such condition. If you move the profile away so that it only sits on one target face, it will work.

Many thanks!

[aldariondb]

I deleted the smaller face but even with just 1 face I am still unable to emboss and still get the same error message. I need the circles that those spots unfortunately.  

Also, I get the same message when I try to deboss the triangle on the sketch. 

[g-andresen · Accepted solution]

Hi,

The lower part of the curve prevents a harmonic transition.
Either create a continuous spline (as in the screencast) or replace the lower curve with a spline and create a tangential transition between the two

günther