Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Need some validation with a slider margin and choice of materials

0 REPLIES 0
Reply
Message 1 of 1
afewyards
189 Views, 0 Replies

Need some validation with a slider margin and choice of materials

afewyards
Explorer
Explorer

So I'm building a little gear lever but I'm not sure my design will work as I have no experience with this.

I'm using a slot pin design where the pin = 6mm and the slot = 6.50. Ideally that would be also 6 as I do not want any wiggle but from what I understand I need to have some space to have no friction.

 

I'm also a bit stuck on materials. what kind of aluminium would you suggest I use for this?

 

thanks in advance!

 

link to project: https://myhub.autodesk360.com/ue2aa3fab/g/shares/SH56a43QTfd62c1cd96826294b3cafe8f6e4

 

there will be a spring attached to the top and bottom spacers

0 Likes

Need some validation with a slider margin and choice of materials

So I'm building a little gear lever but I'm not sure my design will work as I have no experience with this.

I'm using a slot pin design where the pin = 6mm and the slot = 6.50. Ideally that would be also 6 as I do not want any wiggle but from what I understand I need to have some space to have no friction.

 

I'm also a bit stuck on materials. what kind of aluminium would you suggest I use for this?

 

thanks in advance!

 

link to project: https://myhub.autodesk360.com/ue2aa3fab/g/shares/SH56a43QTfd62c1cd96826294b3cafe8f6e4

 

there will be a spring attached to the top and bottom spacers

Tags (2)
Labels (1)
  • CNC
0 REPLIES 0

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report