How do I make a triangle based pyramid?

How do I make a triangle based pyramid?

sabrina.jansta
Community Visitor Community Visitor
1,803 Views
3 Replies
Message 1 of 4

How do I make a triangle based pyramid?

sabrina.jansta
Community Visitor
Community Visitor

I am trying to make a funko pop on Fusion 360 but I 1.) cannot figure out how to make a triangle 2.) Make a triangle based pyramid. 3.) Suck at this!

 

that is the awful nose i ended up with. it sucks. help me please.

0 Likes
1,804 Views
3 Replies
Replies (3)
Message 2 of 4

davebYYPCU
Consultant
Consultant

You are not using sketches.

 

Draw a Triangle in a sketch.  Stop the sketch.

Use the Extrude Tool, and start the solid triangle, set the taper angle, and pull more till it comes to the point, 

 

There are other ways, too.

 

Might help.....

0 Likes
Message 3 of 4

TheCADWhisperer
Consultant
Consultant

Loft to point.

0 Likes
Message 4 of 4

TrippyLighting
Consultant
Consultant

Where did you learn to model with these solid primitives ?


EESignature

0 Likes