Holes in a cone

[michalinakonopka919]

Hello,

I have a problem with modeling a cone with holes. I want to make something like in the picture(on the picture the cone is cut, so you can see what i want to get). As you can see in the picture i want to get a cone with holes, but i want the holes on the top and the bottom to be in the same layout. How do i get this? I tried to do this with sketches and extrude operation, but it always changes the layout on the bottom. 

[TheCADWhisperer]

@michalinakonopka919 

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

[michalinakonopka919]

Here it is

[StephenCim-001]

Is this what you wanted?

[michalinakonopka919]

Not exacily, i want to get on bottom (the bigger one) proporcionally the same size of the holes, like on the top one.

[TheCADWhisperer]

@michalinakonopka919 

I cannot tell from your file what your true Design Intent is, and the image that you posted in your original problem description is very very poor.

Can you search the internet for a better image of something similar to what you are attempting to model?

[Warmingup1953]

A better reference photo may help...What is it? Purpose? Is it to be 3D printed?

[michalinakonopka919]

I want it to look like this, but connected (i want the holes going through the upper and bottom circle)

[laughingcreek · Accepted solution]

a possibility, see attached.

[michalinakonopka919]

Yes, this is exactly what i wanted. Thank you so much for your help.