Fusion 360 for engineers tutorial videos

[whittakerdw]

Where is the video between part 1 lesson 11 and part 2 lesson 11. There are a lot of steps that are done between those two videos and I can't seem to find the video between them. The updated part is provided but the author talks as if these steps were done in a previous step. If they were, I would find it more beneficial to do the steps myself and learn from that instead of downloading the part with the steps already done.

[jodom4]

Hey whittakerdw,

Can you provide a link? I'm not sure which videos you're talking about.

[whittakerdw]

The link for the last video in part 1

https://f360ap.autodesk.com/courses/fusion-360-for-engineers-part-1/lessons/lesson-11-upright-creati...

The link for the first video in part 2

https://f360ap.autodesk.com/courses/fusion-360-for-engineers-part-2/lessons/lesson-11-as-built-joint...

The last thing shown in the last video

The first thing shown in the following video

[whittakerdw · Accepted solution]

Part 1

https://f360ap.autodesk.com/courses/fusion-360-for-engineers-part-1

Last video of this section

Part 2

https://f360ap.autodesk.com/courses/fusion-360-for-engineers-part-2

First video of this section

[Anonymous]

Good day!

I want to follow on this problem

I watched all the videos of fusion 360 for engineers part 1, from lessons 1 to 11 (last lesson of part 1)

Then I started watching fusion 360 for engineers part 2, but the videos started at lesson 11. Is this just a numbering error or lesson 1 to 10 is missing? I think there are some videos that has been skipped since there are things on the part being explained that has been modified already, which we have not seen being done.

Hope for your prompt answer!

Many Thanks

Marlon L. Banal

[jesse.pangburn]

Why is this marked as the "solution"?  This is just restating the problem.