Fusion 360 for Engineers | Part 3 / Lesson 34: Static simulation mesh refinement

[Anonymous]

How can I fix this error:

[matt.bemis · Accepted solution]

Hi @Anonymous,

Thanks for reaching out to us on the forums! I am not positive, but suspect this is due to a 0 degree angle on the part. The mesher will get hung here because the angle gets smaller and smaller and approaches 0 degrees. A quick CAD change should fix this. You can extrude the adjacent face a little bit to create an offset. Feel free to post a .f3d and I will demonstrate how I'd fix this.

Thanks, 

[Anonymous]

Thank you very much. I employed Press/Pull tool and augmented 0.1mm the face you suggested me, and finally I regenerated the mesh.

[matt.bemis]

Hi @Anonymous,

Fantastic news! Great job making the tweak and best of luck with the modeling!

Thanks,