Fillet like edges

[boyleiste]

Hi!

I am new to 3D modelling and Fusion 360. I would be very grateful if you could help me with the project I've attached. Trying to make a handle as in the photo but I couldn't manage the fillet like surfaces on the edges. 

Thank you in advance!

[jhackney1972 · Accepted solution]

I am not sure I like the pattern passing through the main hole.  I like the look of your picture where the pattern does not cross the hole but that is not my call.  You placed the raised area over the hole so I assume you wanted the pattern there.  Everything about my pattern can be edited from the timeline but I caution you, Fusion 360 will take some time to update so do not be impatient.  Model is attached.

[aliobidi]

Hi , 

if you will make exact like the picture 
use "pipe cut" for inner face 
and for outer edges use chamfer 
for inner edges use fillet 

[jhackney1972 · Accepted solution]

I think this looks more like the screen capture you provided and looks much nicer.  If you cannot figure out the timeline, just ask for further help.  Model attached.

[boyleiste]

Dear John,

Thank you very much. It is also very helpful for me but sorry for the misunderstanding. I was asking for the edges that I show on the new picture with the red. If you could help with that too I would be very appreciated. 

Best regards, 

Sabah

[jhackney1972 · Accepted solution]

The sharp inside radii, of the body, make the creation of a chamfer or a sweep very difficult to create.  I will have to think about how to do it.  Maybe someone else has a method I have not thought of.

[boyleiste]

Thank you very much for your help! 🙏 

[boyleiste]

Thank you for your suggestion!

[TrippyLighting]

I believe I've answered your original question in this new thread!